Paint Adhesion Tester PCE-TAT 10

Preparation for use
– Clean the surface of the measuring probe and the surface where you want to place the probe, for example, by using fine sand paper.
– Prepare the epoxy adhesive as instructed on the packaging and mix it thoroughly.
– If you use single-component super glue, open the tube.
– Apply the glue to the surface and place the measuring probe on the surface covered with glue, as described in more detail on the packaging.
– Use the cutter to slightly scratch the area around the measuring probe.

Operation
– Turn the top knob of the adhesion tester counter-clockwise to release the gripping mechanism and the spring.
– Now screw the adhesion tester (thread at the bottom) onto the measuring probe until the device reaches the surface to be tested.
– Turn the top knob clockwise until the measuring head is released from the test surface. You can read the tearing force from scale 1 or 2, depending on the measuring probe used.
– If the measuring probe has not been separated from the surface, turn the knob counter-clockwise to release the spring mechanism and remove the device from the measuring probe.
– Separate the measuring head from the surface, using a chisel and hammer.
– If the measuring probe has been separated from the surface, unscrew it from the device, using the wrench.
– Clean from the surface of the measuring probe any glue and paint residues or splinters.

 

 

Technical specifications
Breakout force	200 kg
Diameter of base dolly, mm	15.1 (№ 1) and 19.5 (№ 2)
Specific breakout force, MPa	Dolly №1 up to 10 MPa (100) Dolly №2 up to 6 MPa (60)
Scale, MPa	1 (№ 1) and 2 (№ 2)
Weight of adhesion tester, kg, no more	1
Dimensions of adhesion tester, mm	150×70
Dimensions of package, mm	L180*W150*H100